Points to pay attention to when placing the beveling machine for a long time

Time：2019-11-28Browse：17

For the beveling machine products that need to be idle for a long time, we should follow the following points when placing the beveling machine:

Important point one: Pay attention to waterproofing for a long time. When the beveling machine is planned to be idle, we should ensure that the place where the machine is placed should be cut off from the water. Waterproofing work should pay attention to several aspects, first from the outside, where the machine is placed. The principle should be the location of the faucet. Secondly, the bevel placement point should be far away from the place where the water pipe is arranged, and the place where the water pipe is arranged should be avoided. The beveling machine products should also be selected at the top of the workshop and the plant floor to prevent rain, so as to ensure that the beveling place is fully waterproof.

Point two: The beveling machine should pay attention to anti-rust. After using the beveling machine for a period of time, the anti-rust paint on the fixing plate, angle wheel and driven wheel of the beveling machine must be damaged. We should brush the oil or place it before placing it. Professional anti-rust oil is on it to achieve the effect of anti-rust. After all, if a large amount of rust is generated, the lighter will take a lot of time to be light, and the heavy one will need to replace the corresponding beveling machine accessories.

Point 3: The place where the automatic beveling machine should be placed should be protected from dust. When preparing the beveling machine for a long time, the beveling machine should be covered with the protective plastic bag on the field, and the packaging wooden box should be covered on it The scattered dust will not fall on the machine but on top of the wooden box. The machine will be very clean next time when the beveling machine is used again.

Point four: The power line of the machine should be disconnected for a long time now, so as to better protect the bevel machine for the next use.